Scenario A – AcuSense camera+ AcuSense NVR

You are here:
< Back

It is recommended to let the AcuSense camera do the false alarm reduction. This will save the AcuSense NVR resources for normal IPC. Please make sure this camera channel has ‘Enable Local Smart Analysis’ unticked.

1) Go to NVR’s web page, Configuration—Event—Smart Event, choose AcuSense camera channel. 

2) Choose and enable event that you want to detect (line crossing, region intrusion, region entrance detection or region exiting detection), draw rules.

3) Choose detection target(s). There are three choices: Human, Vehicle or Human& Vehicle. Then click save. Once the detection target is enabled, AcuSense Camera will filter false alarms based on the algorithm automatically.

NVR FW is V4.20 or above, configurations are just the same as AcuSense camera+ AcuSense NVR

If NVR FW is V4.1xx,
1) Go to NVR’s web page, Configuration—Event—Smart Event, choose the AcuSense IPC channel.
2) Choose and enable event that you want to detect (line crossing, region intrusion, region entrance detection or region exiting detection), draw rules;

3) Go to IPC’s web page, check the target of interest. You can choose between 3 modes: Human, Vehicle or Human & Vehicle. Once the target detection is enabled, the IPC will filter most of the false alarms based on the algorithm automatically.