Customer need to go to Configuration>Image>Display Settings>Exposure Settings to reduce Exposure Time.
Https protocol is Hyper Text Transfer Protocol over Secure Socket Layer. With this protocol,the data transmitted can be encrypted to enhance security level. Hikvision products provide self-signed certificate, which means user can use free Https certificate in local area network. Besides, user can install signed certificate or create certificate request .
This article shows how to configure Https protocol in 3 ways.
1 Self-signed certificate
Self-signed certificate is Hikvision’s private certificate which provides user with secure link to access to device. It’s highly recommended to be used in local area network. Access to the webpage of device (NVR is the sample device in this article), go to
Choose Create Self-signed certificate and click create, input the basic information and click ok.
Check Enable and click Save, a self-signed certificate will be installed into the device.
The address format of https is https://IPaddress:Port, notice that all self-signed certificate will pop out below hint, click Continue to this website.
2 Create certificate request
Hikvision products supports quick-export certificate request, you can upload this request to some official certificate authorities.
Click Create, input basic information of certificate, notice that fixed public IP address or domain name is required as Hostname/IP. Notice: Don’t input request password for NVR which runs an older firmware version than V3.4.62.
After creating request, download it to PC. This request could be used to apply for official https certificate.
3 Install signed certificate
After certificate is signed by official authority, user can install it to the device. Notice that the public IP address or domain name must match the device’s actual IP address. User can access to device with https link in public network.
Notice: (1) Only PEM format certificate is supported; (2) NVR can only recognize the certificate which is generated basing on the request exported by itself; (3) A new signature is required when user re-uploads the certificate.
a) The online device can search for other devices. Go to Control Panel >Device Management >Device >Hikvision device, select “Online device”, click Add to client. Then enter the alias, user name, password and other information and click Add.
b) After the addition, there will be additional devices in the managed devices. Device serial number can be displayed and the network status green, which shows the devices have been added successfully.
c) Go to Control Panel >Main Preview, select the monitoring points, expand the group and double-click the monitoring point in the group to turn on preview. You can also double-click the group folder, which turns on the preview of all the monitoring points in the group.
d) There is no device found on the “Online device”: Go to Control Panel >Device Management >Device >Hikvision device and click Add Device.
Customer should to check through our website. Some cameras support this alarm port while some doesn’t.
The camera heartbeat function exists between IPC and NVR/platform.IPC will transmit the information to NVR/platform, the communication would be built if the NVR/platform recognize the IPC is online.
Select Configuration / System / Maintenance / System Service and enable / check in “Activate a third stream” and press save. NOTE!!! If you start it, you turn off the Acusense function so it is either or.
Then go to events and enable Motion Detection
But user can setup IP address filter, Allow or Forbidden.
IP address filter makes it possible for access control. User can enable the IP address filter to allow or forbid the visits from the certain address.